4 x Studio Due Shark 150 AND 3 X Studio Due Shark L.E.D. PROTOTYPES
This is a package for a small install or mobile set-up.
There are the 4 spots with rotating gobo's so this is the 150C version and 3 l.e.d. washes which were a prototype that Studio Due made.
The spec on the spots is available online and below.
The washes have 3 hexagonal led's and use the base and some electronics of the earlier 150's
Just the units, no hanging brackets included as screw-thread.
The spots have 2 sections of uni-strut bolted to them as that was used at the install they were in last.
I serviced, cleaned and repaired these units in 2011 and again this week ready to sell.
Fully working, in good condition overall though some covers are scratched and fan grills are a bit broken but the best covers i have left in stock from my spares has been used on these.
Lamps are new or very low hours in the spots.
• SOURCE
Lamp: HTI 150W / HTI 152W
Color temperature: 6.900 K
Lamp life: 750 hours
• COLOURS
Color wheel with 6 colours + 6 bi-colours + white, rainbow effect (continuous position)
• OPTIC
Beam angle 18°
• EFFECTS
Strobe: 0,5 to 15 flash/sec
Dimmer: (256 steps)
- 0-40% electronic
- 40-100% mechanical
Fast shutter
Motorized electronic focus (256 steps), 1m-infinite
• GOBOS
Gobo wheel with four rotating gobos + white - continuous positioning + rainbow
• PAN - TILT
8/16 bit quiet and smooth movement
- 540 pan (2.7 sec.)
- 270 tilt (1.6 sec.)
• CONTROL
Standard interface: RS-485 Opto-coupled input
Protocol: USITT DMX512
Auto-mode function with built in games
Local/remote lamp ON/OFF, remote reset by DMX master/slave function
Music synchro with built in microphone and Auto gain or manual gain function
Switches on for anomaly overtemperature or remote reset
• SETUP AND CONFIGURATION
Built-in microprocessor with LED display and buttons
• POWER SUPPLY
Electronic ballast: 100-240V~ ; 50/60Hz with electronic PFC
• DMX CHANNELS
- 12 ch mode
- 11 ch mode
- 10 ch mode
• PHYSICAL
WxDxH: 350 x 315 x 420 mm
Weight: 10 kg.