4 x Studio Due Shark 150 AND 3 X Studio Due Shark L.E.D. PROTOTYPES This is a package for a small install or mobile set-up. There are the 4 spots with rotating gobo's so this is the 150C version and 3 l.e.d. washes which were a prototype that Studio Due made. The spec on the spots is available online and below. The washes have 3 hexagonal led's and use the base and some electronics of the earlier 150's Just the units, no hanging brackets included as screw-thread. The spots have 2 sections of uni-strut bolted to them as that was used at the install they were in last. I serviced, cleaned and repaired these units in 2011 and again this week ready to sell. Fully working, in good condition overall though some covers are scratched and fan grills are a bit broken but the best covers i have left in stock from my spares has been used on these. Lamps are new or very low hours in the spots. • SOURCE Lamp: HTI 150W / HTI 152W Color temperature: 6.900 K Lamp life: 750 hours • COLOURS Color wheel with 6 colours + 6 bi-colours + white, rainbow effect (continuous position) • OPTIC Beam angle 18° • EFFECTS Strobe: 0,5 to 15 flash/sec Dimmer: (256 steps) - 0-40% electronic - 40-100% mechanical Fast shutter Motorized electronic focus (256 steps), 1m-infinite • GOBOS Gobo wheel with four rotating gobos + white - continuous positioning + rainbow • PAN - TILT 8/16 bit quiet and smooth movement - 540 pan (2.7 sec.) - 270 tilt (1.6 sec.) • CONTROL Standard interface: RS-485 Opto-coupled input Protocol: USITT DMX512 Auto-mode function with built in games Local/remote lamp ON/OFF, remote reset by DMX master/slave function Music synchro with built in microphone and Auto gain or manual gain function Switches on for anomaly overtemperature or remote reset • SETUP AND CONFIGURATION Built-in microprocessor with LED display and buttons • POWER SUPPLY Electronic ballast: 100-240V~ ; 50/60Hz with electronic PFC • DMX CHANNELS - 12 ch mode - 11 ch mode - 10 ch mode • PHYSICAL WxDxH: 350 x 315 x 420 mm Weight: 10 kg.